Pack of stock, grip and rail picattiny for Vulkan WE23-s

Tailor-made pack for the Vulkan WE23-s.

• Fully adjustable cylinder head, from 250mm to 287mm from

length and from 20mm to 45mm headrest height.
- Clamps for attaching standard picattiny rails, as the

standard M-Lock screws scrape or impede the rotation of the

barrels.
- Ergonomic angled grip.

Materials needed:

• 35mm M3 screw.
• 25mm M3 screw
• Several M3 nuts (from 9 to 13).
• Screw M8 75mm.
• Screw M8 54mm.
• 4x Nut M8.
• Stainless steel calibrated rod 8mm diameter (300mm).
• Linear bearings 8mm inside, 15mm outside, 24mm height.
• Pin 8mm diameter 45mm long + 3/32" cutter pin.
• M5 threaded rod (500mm we have plenty).
• Two component glue.

Assembly:

• Stock:

  • Inserts in the adjustment wheels, insert the 4 Turks to.

  half print.
  - Cut 8mm rod a:
  - 2x 85mm
  - 2x 56mm
  - Insert the bearings into the respective holes.
  - Insert 8mm x 85mm rods to the cylinder head by pressing.
  - Glue 74mm screw to the cylinder head, place the cylinder head to the body.

  before the glue dries and let it dry assembled,

  for correct seating of the screw shaft.
  - Insert 56mm rods to the head rest by pressure.
  - Bond the screw using the same method as before.
  - Glue the battery cover to the cylinder head body with.

  glue.
  - Cut the M5 threaded rod to make the inserts.

  vertical to the cylinder head, and glue them with glue, for further

  rigidity.

• Handle:

  • Insert M3 nuts into the slots in the handle and rail.

  picattiny.
  - Glue "M-Lock cubes" into the grooves of the handle.

Tips:

• Highly recommended to use the two-component glue, the.

"superglue" leaves white spots on the print.
- Put glue all over the threaded rod to make it stick.

over the entire surface of the insert.