Praga V3S 1/10 Model 6x6

This is my model of Praga V3s, legendary czechoslovakian truck. It includes 3D printable portal axles, gears, driveshafts, transfer case, frame, cab, bed and accesories. It is possible to make it into RC model, however you need quite a lot of experience with 3D modeling. It is also possible to print it just as a static model for a shelf. Everything you need to make it into RC is included, however I am not marketing it as a fully fledged RC model, because it takes some improvisation and customization to really convert it into RC (completely doable for model engineer, but not for someone new to RC builds).

All the files were printed on classic Ender 3, you only need PLA and PETG for the frame. However, feel free to substitute to better materials such as ASA, PC, PA-CF or anything else - this model is from the Ender 3 era, when these fancy materials were out of the reach for most hobbyists.

This build also includes quite a few non-printed parts, mainly screws, bearings, tires (I was not able to print TPU back then) and some ball joint linkages. Tires are standard size, so you can download and print some TPU ones and they should fit. If you really want to turn it into RC, you will also need motor with planetary gearbox, servo, ESC, battery, etc.

It is also possible to just use my cab and bed for your RC build, using bought axles and steel frame. You also get all the accesories, storage boxes, jerry cans, hitch, lots of little things for the scale looking build.

You can find some additional photos and discussion from my original build on this Slovak RC forum: https://www.rcportal.sk/praga-v3s-am10029

Here is video of the truck in action:
https://youtu.be/wshycJLtzRs

If you are up for a challenge, I wish you a good luck with the build :)