VENOM-S | R/C 3D PRINTED 64MM EDF SPORT JET

The VENOM-S was born after dozens of successful flights with the original 90mm VENOM.

After flying the larger version extensively, I wanted to design a smaller, simpler, and more affordable jet to build, while keeping the same flying characteristics that made the original VENOM so enjoyable.

This is how the VENOM-S came to life: easy to build, simple to hand launch, fast, powerful, and aerobatic, yet still docile and capable of smooth low-speed flight.

I hope you’ll enjoy building and flying the VENOM-S as much as I did :)

Make sure to carefully read the Build Manual before starting to print the VENOM-S.

VIDEOS AND COMMUNITY

• LSPlanes Youtube Channel: LSPlanes
• LSPlanes Facebook Group: Community Group
• Flight Video: See how it flies!
• Build Guide Video: How to build it
• Free Test Files: Download

KEY FEATURES

• Straightforward assembly
• Easy to hand launch and landing
• Electronics can be installed after full airframe assembly
• Large internal wire channels for clean cable routing
• Compatible with common RC electronics
• Completely 3D printable without supports
• 200x200x200mm build volume required

MODEL DATA

• Power system: 64mm EDF
• Battery: 4S 2200mAh LiPo
• Wingspan: 970mm
• Length: 900mm
• Ready-to-fly weight: approx. 1100g

WHAT'S INCLUDED

• Complete STL files for the VENOM-S
• Detailed Build-guide video
• Pre-oriented .stl files for easy printing
• .3mf files with custom LW-PLA settings

ELECTRONICS REQUIRED

List of the parts I have used for the build

• 64mm EDF (3300KV)
• 60/80A ESC
• 3.5mm connectors (you might need them depending on your ESC)
• 4S 2200mAh LiPo Battery
• Velcro straps
• Receiver: 4–6 channels
• Servos (9–12g, metal gears)
• Carbon tube (1× 500mm × 6mm)
• 2mm Carbon rods
• Linkages (1.5mm steel rods)
• Linkage stoppers (2.1mm diameter)
• Round magnets 12× (6 × 3mm)
• Servo extensions (15cm & 20cm + Y cables)
• Servo reverser (only needed with 4-ch receivers)

Some of the links above are affiliate links.

If you purchase through these links, I may earn a small commission at no extra cost to you.

This helps support the channel and future projects — thank you! 🙏

IMPORTANT INFORMATION

• DIGITAL DOWNLOAD – no physical parts included
• STL files are for personal use only
• Redistribution or resale is not permitted

UPDATES

20-12-25
- Files Release

24-12-25
- Modified the Build Manual adding informations about the different control surfaces hinges
- Small update of the vertical tail, which had the Alignment Tab slot too small. Made it the correct dimension. Modification added to the .3mf file too